VERTICAL MILLING MACHINE

Vertical Milling Machine

CVM 500

The ideal miniature machine for model makers, hobbyists, jewellers, educational institutions and many other professions. The Vertical Milling Machine comes complete with base, bed, vertical slide, headstock, t-slotted table, lead screw and motor. Also included: 5/32" milling cutter (#740), belt (#500), set of two T-nuts (#765), set of two socket screws, two keys, warranty card and a brief sheet of safety instructions. All you have to supply is a 12-volt power source. You may use a 12-volt car battery, 12-volt battery charger or a 12-volt DC variable speed controller/ transformer to vary the speed of the motor.

OUT OF STOCK!

Prices are listed in Australian and US currency only.
Refer to Ordering Info for postage prices.

The Milling Machine is suitable for almost all types of materials except those that are high tensile. Due to the small nature of the machine, we recommend soft materials such as brass, aluminium and mild steel. Accessories included with the Milling Machine are a set of 2 T-nuts and 2 wrenches. All milling cutters are 3/16" and are held by means of a grub screw pinching the side of the cutter. Clearance from the bottom of the cutter to the table is 3.625". All slides are adjusted with gibs and screws. The lathe headstock (part#215) may be purchased to use the milling machine as a drill press. Therefore, the chucks for the lathes may be used on the mill

SPECIFICATIONS
Table length	6"(153mm)
Table width	1 9/16"(40mm)
Table travel	3 3/4"(95mm)
Cross travel	2 1/2"(64mm)
Vertical travel	4"(100mm)
Max. dist. Table to spindle	4 1/2"(115mm)
Lead screws	20 t.p.i.
Hand wheel graduations	.001" per division
Spindle speed	Up to 4000 rpm
Motor	12 volt, 4 amps (max)
Overall length	6 1/4"(160mm)
Height	10 1/4"(265mm)
Width	6 3/4"(170mm)

SPECIFICATIONS